CITATION — REFERENCE ENTRY
Hand Jive! Master the Fundamentals of Lap Steel — Premier Guitar
- Key
- ellis2016-hand-jive
- Authors
- Ellis, Andy
- Issued
- 2016-7-2
- Type
- article-magazine
- Container
- Premier Guitar
Raw CSL JSON
{
"URL": "https://www.premierguitar.com/lessons/hand-jive-master-the-fundamentals-of-lap-steel",
"note": "A lap steel lesson, not specific to the dobro.",
"type": "article-magazine",
"title": "Hand Jive! Master the Fundamentals of Lap Steel",
"author": [
{
"given": "Andy",
"family": "Ellis"
}
],
"issued": {
"date-parts": [
[
2016,
7,
2
]
]
},
"accessed": {
"date-parts": [
[
2026,
11,
21
]
]
},
"container-title": "Premier Guitar"
}
Claims
-
The bar is also called a "tonebar" or "steel", and is traditionally a metal cylinder with a rounded "bullet nose" tip.
"Steel guitar is all about the tonebar, which is also known as simply a “bar” or sometimes a “steel.” Bars come in different sizes and materials, but traditionally steelers use a metal cylinder with a rounded tip or “bullet nose.”"
-
Andy Ellis writes that the bar's contact point cannot really be seen, so experienced steel players play in tune by ear, not by sight.
"Because your viewing angle shifts as you move the bar up or down the strings, you can’t really see where its miniscule contact point sits relative to the fret marker. Experienced steelers play by ear, not by sight."
-
In a forward slant the bar's tip points toward the bridge, and in a reverse slant toward the nut.
"And there are two possible orientations for the slant: The bar tip can point either toward the bridge or toward the nut. We’ll call the first position a forward slant and the latter a reverse slant."
-
Andy Ellis calls sliding into a note from below, the "hammer-slide", a quintessential steel move.
"But rather than landing directly over the 3rd fret marker, slide toward it from below, as indicated in the notation. This “hammer-slide” is a quintessential steel move, as is its mirror image, the “slide-pull” you’ll encounter in beat 4."
-
With no physical frets, a steel player must adjust intonation by hand while playing, often at quick tempos.
"Because we don’t have physical frets to do the dirty work for us, we have to intuitively make intonation adjustments by hand, on the fly—often at quick tempos."
-
On steel instruments, hammer-ons and pull-offs alternate a note under the bar with an open string; Ellis makes a pull-off by lifting the bar off the plucked string.
"On steel, pulls and hammers consist of alternating a bar note with an open string. Beat 1 illustrates a pull-off on the 3rd string. Simply place the bar over the 1st fret marker, pluck A, and lift the bar off the string."
-
On the steel guitar, Andy Ellis writes, the picking hand does most of the muting.
"Though the left hand is actively involved in muting, it’s the right hand—the picking hand—that does the lion’s share."
-
Andy Ellis advises a vibrato that rolls back and forth around the target note, going sharp and flat in equal amounts at a fixed speed.
"You want to hit your target note and then roll back and forth above and below it using the same amount of variation and a steady pulse. In other words, go sharp and flat in equal amounts at a fixed speed."
Available in